低成本、率、以工作质量保证产品质量

购买二手叉车需注意哪些问题？

来源：https://www.jnhgjx.net/ 日期：2024-04-07 发布人：

购买二手叉车，为的是节约投资成本，尽快产生好的经济效益，但是，如果您没有挑选好叉车，那么，您就可能药罐子，耽误生产不说，天天维修，简单介绍一下二手叉车的挑选应该注意哪些?

Buying a second-hand forklift is to save investment costs and generate good economic benefits as soon as possible. However, if you haven't selected a good forklift, you may have bought a medicine jar, which will delay production and require daily maintenance. Here is a brief introduction to what should be paid attention to when selecting a second-hand forklift?

一看：怎么看?看那里?要站在正前方，看门架上下的间隙是否一致，如上下不一，证明此叉车曾经因超负荷长时间工作过，或有过事故.蹲下，看正后方下面的转向系统是否和介绍的一致，转向分机械和液压二种，液压也分全液压和机械液压混合的，全液压，也就是俗称的横直缸，机械的叫三联板，也许各地方叫法不同但是，具体的意思大家能明白.看所有的连接部位的间隙是否很大，如果大，证明此车使用率较高，买后，很可能会增加维修成本。

Take a look: What do you think? Where are you looking? To stand in front of the forklift, check if the gap between the top and bottom of the gantry is consistent. If the gap is different, it indicates that the forklift has worked for a long time due to overload or has had an accident. Crouch down and check if the steering system below the front is consistent with the introduction. There are two types of steering: mechanical and hydraulic, and hydraulic pressure is also mixed with full hydraulic and mechanical hydraulic. Full hydraulic, also known as horizontal cylinder, mechanical is called triple plate. Although the name may vary in different places, the specific meaning can be understood. Check if the gap between all connecting parts is large, which indicates that the vehicle has a high usage rate and may increase maintenance costs after purchase.

二听：将车发动起来，听发动机的声音是否有明显的答答声，发动机运转是否平稳，加几次长油门后，将油门放掉，看发动机的反应是否灵敏如有缺陷，您应该知道怎么做了。

Second listen: Start the car and listen for a noticeable answering sound from the engine. Check if the engine runs smoothly. After adding a few long throttle strokes, release the throttle and check if the engine responds sensitively. If there are any defects, you should know what to do.

三试：空载试车，负荷满载，看整车的性能，如果能达到新车85%以上的，应该算不错了，千万别轻信那些超载试车，大油门试车一般的问题不容易发现，空载，负荷都要小油门和中油，满载停车，熄火，看门架上的货物是否下沉，时间要5分种左右。

Three attempts: no-load test, full load test, check the performance of the entire vehicle. If it can reach 85% or more of the new car, it should be considered good. Don't trust those overloaded test runs. Generally, problems with high throttle test are not easy to detect. When unloaded, the load should be low throttle and medium oil. When fully loaded, stop the car, turn off the engine, and check if the goods on the door frame sink. It takes about 5 minutes.