低成本、率、以工作质量保证产品质量

　　Electric forklift, as the name implies, is a forklift with battery as the core controller! In addition, in order to provide more functions for electric forklift, and to achieve these functions, more harnesses are often needed to control. Then, once the electric forklift works for a long time or forecasts the high temperature weather, it is necessary to know the measures to prevent the electric forklift circuit harness from burning out!

　　1. 在使用过程中，经常会发现一些电动叉车布线混乱，冗余电线和外露电线较多，随机布线也较为常见。结果导致整车线路混乱，往往导致人为的线路故障，难以发现。严重时会发生铁短路，烧毁电气设备和线束，造成火灾事故，直接影响叉车的运行。

　　1. In the process of use, it is often found that some electric forklift cables are disordered, redundant wires and exposed wires are more, and random wiring is also more common. As a result, the whole vehicle line is in disorder, which often leads to artificial line fault, which is difficult to find. In serious cases, iron short circuit will occur, electrical equipment and wiring harness will be burned, resulting in fire accidents, which will directly affect the safe operation of forklift.

　　2,在维护叉车电路线束,维修必须遵守规范,按照叉车低线颜色和代码的数量和布置标准连接,不能单独见面时,故障没有排除电源线,或一条线段破坏,无论颜色,无论厚度,只是随便,会人为地增加车辆电路线束混乱,失败的后果。在更换保险丝之前，应按要求关闭和更换所有电气设备和点火开关。

　　2. In the maintenance of forklift circuit harness, the maintenance must comply with the specification, connect according to the number and layout standard of low line color and code of forklift. When it is not able to meet alone, the fault does not eliminate the power line, or a line segment is damaged, regardless of color, regardless of thickness, just casually, it will artificially increase the chaos of vehicle circuit harness and the consequences of failure. Before replacing fuses, turn off and replace all electrical equipment and ignition switches as required.

　　3.如果更换后的保险丝再次烧坏，说明系统有短路，应仔细检查并排除故障后更换系统。有电源总开关的叉车，停车后应关闭电源总开关。定期检查、维护和调整电路熔丝，必要时更换新部件。

　　3. If the replaced fuse burns out again, it means that there is a short circuit in the system. Check carefully and remove the fault before replacing the system. For forklift with main power switch, turn off the main power switch after parking. Check, maintain and adjust circuit fuse regularly, and replace new parts if necessary.

　　电动叉车电路故障多为隐蔽故障，多由电线引起。叉车电源线短路是常见的线路烧损，电源线不使用短路过载保护装置。

　　Most of the circuit faults of electric forklift are hidden faults, which are caused by wires. Forklift power line short circuit is the most common line burn, power line does not use short circuit overload protection device.