低成本、率、以工作质量保证产品质量

购买二手叉车需注意哪些问题？其实济南二手叉车本身出厂的时候是没有区别，区别的是出厂之后被用在什么地方。如果是在平整的仓库里，同样的使用时间内这类叉车的损坏情况会小很多。如果是在户外，特别是在工地，叉车的损坏会比较严重。

What should I pay attention to when purchasing second-hand forklift? In fact, there is no difference when the second-hand forklift truck in Jinan leaves the factory. The difference is where it is used after leaving the factory. If it is in a flat warehouse, the damage of this kind of forklift will be much smaller within the same service time. If it is outdoors, especially at the construction site, the damage of the forklift will be serious.

每个的叉车质量也大不相同，有些叉车本身质量够好，及时使用时间长了，二手叉车本身的保值度也依旧很好。不能仅看外表，市面上大部分的二手叉车都是经过翻新处理的。在购买叉车的时候要好好的检查叉车剩余性能是否还可以投入运作，如果不能果断放弃，免得买回去之后还要花费很多的修理费用，得不偿失。对整部叉车要有系统性的检查，包括控制系统、动力系统等，可以通过加减油门、聆听发动机的声音等方法来一一鉴别。

The quality of forklifts of each brand is also very different. Some forklifts are of good quality and have been used for a long time. The value of second-hand forklifts is still very good. You can't just look at the appearance. Most second-hand forklift trucks on the market are renovated. When purchasing a forklift, carefully check whether the remaining performance of the forklift can still be put into operation. If you cannot give up decisively, you will not have to spend a lot of repair costs after buying it back. The whole forklift should be checked systematically, including the control system, power system, etc., which can be identified one by one by increasing or decreasing the throttle, listening to the sound of the engine, etc.

蹲下来检查一下二手叉车正后方下面的转向系统是否和别人介绍的一致。转向分机械和液压二种：液压又分全液压和机械液压混合的，全液压也就是俗称的横直缸，机械的叫三联板。另外还需查看二手叉车所有的连接部位间隙是否很大，如果很大，证明此叉车使用率较高，购买之后很可能会产生大笔的维修费用。

Squat down and check whether the steering system under the front of the second-hand forklift is consistent with the one introduced by others. There are two types of steering: mechanical and hydraulic. Hydraulic pressure is also divided into full hydraulic pressure and mechanical hydraulic pressure. Full hydraulic pressure is also commonly known as horizontal cylinder, and mechanical pressure is called triple plate. In addition, it is also necessary to check whether the gap between all the connecting parts of the second-hand forklift is large. If it is large, it proves that the use rate of this forklift is high, and it is likely to incur large maintenance costs after purchase.

将二手叉车发动起来，听发动机的声音是否有明显的答答声，发动机运转是否平稳，加几次长油门后，将油门放掉，看发动机的反应是否灵敏。

Start the used forklift truck, listen to the sound of the engine to see if there is an obvious answer, and whether the engine runs smoothly. After adding a few long throttle, release the throttle to see if the engine responds sensitively.

购买二手叉车时，需空载试车、负荷满载，看整个二手叉车的性能如何，如果能达到新车85%以上的，就已经很不错了，切记不要轻信那些超载试车的，大油门试车一般的问题不容易被发现，所以空载，负荷都要小油门和中油，满载停车，熄火，看门架上的货物是否下沉，时间要5分种左右。

When buying a second-hand forklift, you need to test it with no load and full load. It depends on the performance of the whole second-hand forklift. If it can reach more than 85% of the new car, it will be very good. Remember not to trust those who test it with overload. The general problems of large throttle test are not easy to be found. Therefore, it takes about 5 minutes to stop and stop with full load and check whether the goods on the gantry sink.

二手叉车都有不同程度的损坏，要衡量它的损坏程度，计算所需要的修理费用，这样子才可以节省资源，采购二手叉车是一份需要耐心需要技术的任务，一部一部的检查计算，挑选保值度高的叉车，为自己节省开支。更多相关内容就来我们网站http://www.jnhgjx.net咨询吧！

Second-hand forklifts have different degrees of damage. It is necessary to measure the degree of damage and calculate the required repair costs, so that resources can be saved. Purchasing second-hand forklifts is a task that requires patience and technology. Check and calculate one by one, select forklifts with high value preservation, and save money for yourself. Come to our website for more relevant content http://www.jnhgjx.net Ask!