内燃叉车日常保养事项
来源：https://www.jnhgjx.net/ 日期：2024-02-28 发布人：
应用前查验：
Pre application verification:
检查项目如下：
The inspection items are as follows:
1）检查汽柴油，润滑脂、齿轮油和冷冻液是不是加满
1) Check if the gasoline, diesel, lubricating grease, gear oil, and coolant are fully filled
2）查验整车油、水有没有渗漏状况
2) Inspect the entire vehicle for oil and water leaks
3）查验各仪表盘、数据信号、照明灯具、电源开关、按键以及其他附设机器设备工作情况
3) Inspect the operation of various instrument panels, data signals, lighting fixtures, power switches, buttons, and other attached machinery and equipment
4）查验汽车发动机有一样，工作中能否一切正常
4) Check if the car engine is functioning properly during operation
5）查验转为，制动系统，车胎和牵引带设备的工艺情况及拧紧状况
5) Inspect the process and tightening condition of the brake system, tires, and traction belt equipment
6）查验起吊组织，歪斜组织，轮架和液压传动系统的工艺情况及拧紧情况
6) Inspect the process and tightening conditions of lifting organization, skewed organization, wheel frame, and hydraulic transmission system
7）查验随车工具及配件是不是性
7) Check if the accompanying tools and accessories are safe
贵阳叉车租赁之内燃叉车日常保养有哪些
What are the daily maintenance of internal combustion forklifts in Guiyang forklift rental
工作上检查项目
Work inspection items
通常指在工作中2h功效开展
Usually refers to the effective implementation within 2 hours of work
检查项目如下
The inspection items are as follows
1）查验汽车发动机、汽车底盘、工作中设备、液压传动系统、仪表盘及数据信号设备的工作情况
1) Inspect the operation of the car engine, chassis, working equipment, hydraulic transmission system, instrument panel, and data signal equipment
2）查验轴榫、制动系统鼓、变速箱、变矩器、齿轮油泵和驱动器溫度是不是一切正常
2) Check if the temperature of the shaft tenon, brake system drum, gearbox, torque converter, gear oil pump, and driver is normal
3）查验车胎、转为和制动系统设备的情况和固定状况
3) Inspect the condition and fixation of the tires, steering, and braking system equipment
4）查验汽车机油、冷冻液、齿轮油的釉面层相对高度和溫度及其整车油、水有没有渗漏状况
4) Check the relative height and temperature of the glaze layer of car oil, coolant, and gear oil, as well as whether there is any leakage of the entire vehicle oil and water
回库后维护保养新项目
New maintenance projects after returning to the warehouse
检查项目如下
The inspection items are as follows
1）清理叉车
1) Cleaning forklifts
2）加上汽柴油，查验润滑脂、冷冻液、齿轮油、液力传动油、北方地区冬天若不加汽车防冻液或沒有暖库应放入冷冻液
2) Add gasoline and diesel, check lubricating grease, coolant, gear oil, hydraulic transmission oil, and in winter in northern regions, if car antifreeze is not added or there is no warm storage, add coolant
3）查验V带的完整状况和松紧
3) Check the integrity and tightness of the V-belt
4）查验轮胎气压标准
4) Check tire pressure standards
5）查验轮架、起重吊装链绷紧地脚螺栓的拧紧状况
5) Check the tightening status of the anchor bolts for the wheel frame and lifting chain tension
6）查验调节储油罐、歪斜液压缸、转为液压缸和各三通接头的渗透状况
6) Inspect and adjust the permeability of the oil storage tank, skewed hydraulic cylinder, converted hydraulic cylinder, and all three-way joints
7）工作上发觉的常见故障
7) Clear common faults found in work
8）查验、梳理随车工具及配件
8) Inspect and sort out on-board tools and accessories
9）每工作中40~50小时应提升以下新项目：清理各空气滤芯；清理电瓶外界，查验锂电池电解液液位相对高度和电级柱、电极连接线的清理、拧紧状况；查验分电器接触点，润化分电器轴和凸轮轴；查验拧紧整车各构成外界易松脱的地脚螺栓；对离心水泵滚动轴承，转向拉杆主销后倾角、横、直支撑杆轴管，歪斜储油罐横销，三联板核心销；对起重链条开展润滑油和调节。
9) The following new items should be improved every 40-50 hours of work: cleaning each air filter element; Clean the outside of the battery, check the relative height of the electrolyte level in the lithium battery, and check the cleaning and tightening status of the battery level column and electrode connection wires; Inspect the contact points of the distributor, lubricate the distributor shaft and camshaft; Check and tighten the anchor bolts that are easily loosened from the outside of the vehicle components; For centrifugal water pump rolling bearings, steering rod main pin tilt angle, horizontal and straight support rod shaft tubes, skewed oil storage tank horizontal pins, and triple plate core pins; Lubricating oil and adjusting the lifting chain.
鲁公网安备 37011202000702号
