低成本、率、以工作质量保证产品质量

叉车在驾驶过程中偶尔会出现转向沉重方向的现象，特别是给叉车司机带来头痛，将系统转向重要的“叉车配件”后，日常生活中难免会出现一些故障。怎么解决叉车方向盘太重转不动问题？济南叉车租赁厂家为您讲解。

Forklifts occasionally turn to the heavy direction during driving, especially causing headaches for forklift drivers. After turning the system to the important "forklift accessories", some failures will inevitably occur in daily life. How to solve the problem that the steering wheel of the forklift is too heavy to turn? Jinan forklift rental manufacturer will explain to you.

原因

reason

1、油泵损坏或故障

1. The oil pump is damaged or faulty

2、节流阀堵塞或损坏

2. The throttle valve is blocked or damaged

3、软管接头损坏或管道堵塞

3. The hose connector is damaged or the pipe is blocked

解决方法

resolvent

1、更换油泵

1. Replace the oil pump

2、企管系可以替代子阀门

2. The enterprise management system can replace the sub-valve

3、清洁或更换管道

3. Clean or replace pipes

叉车方向盘太重原因

Reasons for heavy forklift steering wheel

1、油门压力太低

1. Throttle pressure too low

2、油路上有空气

2. There is air on the oil circuit

3、转向缸泄漏太大

3. Steering cylinder leakage is too large

叉车方向盘太重解决方法

Solution to heavy steering wheel of forklift

1、调节节流流量

1. Adjusting throttle flow

2、油道中的空气

2. Remove the air from the oil passage

3、更换活塞密封

3. Replace piston seal

每次出故障都要去修理厂修理，这肯定是件麻烦事。因此，在日常使用中注意自我检查很重要，更多相关内容就来我们网站http://www.jnhgjx.net做咨询吧！

Every time there is a fault, you have to go to the repair shop to repair it. This must be a troublesome matter. Therefore, it is important to pay attention to self-inspection in daily use, and more relevant content will come to our website http://www.jnhgjx.net Do consulting!