低成本、率、以工作质量保证产品质量

1. Only trained drivers with driving licenses can drive.

2、在开车前检查各控制和警报装置，如发现损坏或有缺陷时，应在修理后操作。

2. Check all control and alarm devices before start-up. If damage or defect is found, it shall be operated after repair.

3、搬运时不应超过规定负荷，货叉须全部插入货物下面，并使货物均匀放在货叉上，不许用单个货叉尖挑货物。

3. During handling, the specified load shall not be exceeded. The fork must be fully inserted under the goods and the goods shall be evenly placed on the fork. It is not allowed to pick the goods with the tip of a single fork.

4、平稳地进行起动、转向、行驶、制动和停止，在潮湿的或光滑的路面，转向时须减速。

4. Start, turn, drive, brake and stop smoothly. Slow down when turning on wet or smooth roads.

5、装物行驶应把货物放低，门架后倾。

5. When loading, lower the goods and tilt the gantry backward.

6、坡道行驶应小心行驶，在大于十分之一的坡道是行驶时，上坡应向前行驶，下坡应后退行驶，上、下坡忌转向，叉车在行驶时，请勿进行装卸作业。

6. When driving on a ramp, drive carefully. When driving on a ramp greater than one tenth, drive forward uphill and backward downhill. Do not turn uphill and downhill. Do not load and unload when the forklift is driving.

7、行驶时应注意行人、障碍物和坑洼路面，并注意叉车上方的空隙。

7. When driving, pay attention to pedestrians, obstacles and potholes, and pay attention to the gap above the forklift.

8、不准人站在货叉上，车上不准载人。

8. No one is allowed to stand on the fork and no one is allowed on the car.

9、不准人站在货叉下，或在货叉下行走。

9. No one is allowed to stand or walk under the fork.

10、不准从司机座以外的位置上操纵车辆和属具。

10. It is not allowed to operate vehicles and accessories from positions other than the driver's seat.

11、不要搬运未固定或松散堆垛的货物，小心搬运尺寸较大的货物。

11. Do not handle goods that are not fixed or loosely stacked, and handle goods with large size carefully.

12、起升高度大于3米的高门架叉车应注意上方货物掉下，必要时须采取防护措施。工作时应尽量使门架后倾，并在小范围内作前后倾。

12. For high gantry forklift with lifting height greater than 3m, pay attention to the falling of goods above, and take protective measures if necessary. During operation, the gantry shall be tilted back as far as possible and tilted back and forth within the minimum range.

13、加燃油时，司机不要在车上，并使发动机熄火，在检查电瓶或油箱液位时，不要点火。

13. When refueling, the driver shall not be on the vehicle and turn off the engine. When checking the liquid level of battery or fuel tank, do not ignite.

14、离车时，将货叉下降着地，并将档位手柄放在空档位置，发动机熄火并断开电源，将手制动拉好，在坡道停车时，还须用垫块垫住车轮。

14. When leaving the vehicle, lower the fork to the ground, place the gear handle in the neutral position, turn off the engine and disconnect the power supply, pull the hand brake, and cushion the wheels with cushion blocks when parking on the ramp.

今天小编给大家呈现就是关于济南叉车租赁的相关知识，如果您对于本文有什么疑问及问题欢迎来电咨询或者网站下边留言：http://www.jnhgjx.net

Today, Xiaobian presents you the relevant knowledge about forklift leasing in Jinan. If you have any questions and questions about this article, please call us or leave a message at the bottom of the website: http://www.jnhgjx.net