低成本、率、以工作质量保证产品质量

假设保养好，日常保养和等级保养到位，叉车可以继续使用。那么不同阶段的叉车保养要注意什么？下面小编为您解析。

Assuming that the maintenance is good, daily maintenance and level maintenance are in place, the forklift can continue to be used. So what should be paid attention to during the maintenance of forklift at different stages? The following is the analysis for you.

叉车使用初期阶段

Early stage of forklift use

叉车使用初期故障率高低是随制造或维修质量和走合时期的使用有关。如果内燃叉车、电动叉车制造或修理质量高，并能正确地使用与维护，初期故障率就低。否则早期故障率会高。

The failure rate of the forklift at the initial stage of use is related to the manufacturing or maintenance quality and the use during the running-in period. If the internal combustion forklift and electric forklift are manufactured or repaired with high quality and can be used and maintained correctly, the initial failure rate will be low. Otherwise, the early failure rate will be high.

早期内燃叉车、电动叉车故障多是联接螺栓松动或松脱；管道接头松动或松脱：残留金属屑或铸造砂易堵塞油道或夹在相对运动摩擦中拉伤机件(如液压系统中的执行机构油缸)造成漏油，调整后的间隙或压力发生变化，使机件不能执行规定能力，有些接合因内燃叉车、电动叉车螺栓不紧而漏水、漏油、漏气等。

In the early stage, the failure of internal combustion forklift and electric forklift was mainly caused by loose or loose connecting bolts; Loose or loose pipe joints: residual metal chips or casting sand are easy to block the oil passage or pull the parts (such as the actuator oil cylinder in the hydraulic system) in the relative motion friction, causing oil leakage. The adjusted clearance or pressure changes, making the parts unable to perform the specified capacity. Some joints leak water, oil and gas due to the loose bolts of the internal combustion forklift and electric forklift.

叉车正常使用阶段

Normal use stage of forklift

泰安合力叉车在正常使用阶段，只要按规定维护和正确使用，一般不会发生故障，所以故障率很低，曲线平缓微升。如果内燃叉车、电动叉车在正常使用期内发生故障，多属偶然性或因使用、维护不当所致。

In the normal use stage, Taian Heli Forklift will not fail as long as it is maintained and used correctly as required, so the failure rate is very low, and the curve rises slightly. If the internal combustion forklift and electric forklift fail during the normal use period, it is mostly caused by accident or improper use and maintenance.

叉车使用接近大修期阶段

The use of forklift is close to the overhaul period

当内燃叉车、电动叉车使用接近大修期时，各部件损耗增大，技术状况恶化。

When the use of internal combustion forklift and electric forklift is approaching the overhaul period, the loss of each component increases and the technical condition deteriorates.

这个阶段的内燃叉车、电动叉车故障特点是故障率高，而且普遍，多数是因磨损过甚和零件老化所造成，油路中的堵、漏、坏现象出现较多。

The faults of internal combustion forklift and electric forklift at this stage are characterized by high failure rate and widespread, most of which are caused by excessive wear and aging of parts, and there are many phenomena of blockage, leakage and damage in the oil circuit.

叉车故障率的高低与季节有关。冬季低温使用内燃叉车、电动叉车时，故障率高于夏季。例如，燃料供给在冬季常因气温低雾化不良。更多相关内容就来我们网站http://www.jnhgjx.net咨询吧！

The failure rate of forklift is related to the season. When using internal combustion forklift and electric forklift at low temperature in winter, the failure rate is higher than that in summer. For example, fuel supply in winter is often poor due to low temperature atomization. Come to our website for more relevant content http://www.jnhgjx.net Ask!