低成本、率、以工作质量保证产品质量

有无发生事故

Whether there is any accident

先要注意观察，人要站在二手叉车正前方，仔细看叉车门架上下的间隙是否一致，如上下不一的话，证明此叉车曾经超负荷长时间工作过或者此发生过事故。

First of all, pay attention to the observation. People should stand in front of the second-hand forklift and carefully check whether the gap between the upper and lower forklift door frames is consistent. If the above and below are different, it proves that the forklift has been overloaded for a long time or that there has been an accident.

二、核心部件的损耗程度

2、 Loss degree of core components

蹲下来检查一下二手叉车正后方下面的转向系统是否和别人介绍的一致。转向分机械和液压二种：液压又分全液压和机械液压混合的，全液压也就是俗称的横直缸，机械的叫三联板。另外还需查看二手叉车所有的连接部位间隙是否很大，如果很大，证明此叉车使用率较高，购买之后很可能会产生大笔的维修费用。

Squat down and check whether the steering system behind the second-hand forklift is consistent with that introduced by others. There are two kinds of steering: mechanical and hydraulic: hydraulic is also divided into full hydraulic and mechanical hydraulic. Full hydraulic is commonly known as horizontal cylinder, and mechanical is called triple plate. In addition, it is also necessary to check whether the gap between all the connecting parts of the used forklift is large. If it is large, it proves that this forklift has a high utilization rate, and it is likely to incur a large amount of maintenance costs after purchase.

三、反应是否灵敏

3、 Whether the reaction is sensitive

将二手叉车发动起来，听发动机的声音是否有明显的答答声，发动机运转是否平稳，加几次长油门后，将油门放掉，看发动机的反应是否灵敏。

Start the second-hand forklift, listen to the sound of the engine to see whether there is an obvious answer, and whether the engine runs smoothly. After adding the long throttle for several times, release the throttle to see whether the engine responds sensitively.

四、按照步骤试车

4、 Test run according to steps

购买二手叉车时，需空载试车、负荷满载，看整个二手叉车的性能如何，如果能达到新车85%以上的，就已经很不错了，切记不要轻信那些超载试车的，大油门试车一般的问题不容易被发现，所以空载，负荷都要小油门和中油，满载停车，熄火，看门架上的货物是否下沉，时间要5分种左右。

When buying a second-hand forklift, it needs no-load test run and full load. It depends on the performance of the whole second-hand forklift. If it can reach more than 85% of the new car, it will be very good. Remember not to trust those who have overloaded test run. The general problems of high throttle test run are not easy to be found, so when no-load, the load should be small throttle and medium oil, stop when full load, shut down when full load, and check whether the goods on the gantry sink. The time should be about 5 minutes.

五、车辆维修使用费用

5、 Vehicle maintenance and use cost

济南叉车租赁厂家认为明智的消费者买车之后还能够养得起车，车辆的日常使用维护费用对车辆的残值影响也很大。所以一些消费者大都数是选择合力和杭州叉车的二手比较多的!

Jinan forklift rental manufacturers believe that wise consumers can still afford to buy cars, and the daily use and maintenance costs of vehicles also have a great impact on the residual value of vehicles. Therefore, most of some consumers choose Heli and Hangzhou forklift trucks for second-hand use!

一些大厂家在上海服务网点多，维修质量好，零配件便宜，日常保养费用低，油耗低，光这几项每年就能为消费者节省数千元上万元的必要费用。这些车经济实惠必然会吸引更多的旧车购买用户，所以车辆使用维护的方便和经济程度也影响车辆自身残值。一些进口车、国产小厂家的车型往往因为零配件少、维护保养高而造成人为残值。

Some large manufacturers have many service outlets in Shanghai, with good maintenance quality, cheap spare parts, low daily maintenance costs and low fuel consumption. These items alone can save thousands of yuan and tens of thousands of yuan of necessary expenses for consumers every year. These cars are economical and will inevitably attract more used car buyers, so the convenience and economy of vehicle use and maintenance also affect the residual value of the vehicle itself. Some imported cars and models of small domestic manufacturers are often made into residual value due to the lack of spare parts and high maintenance prices.

建议选购二手叉车要注意的五个要点就是以上内容了，如果您有兴趣咨询问题就来我们网站http://www.jnhgjx.net吧。

It is suggested that the above five points should be paid attention to when purchasing second-hand forklifts. If you are interested in consulting questions, please come to our website http://www.jnhgjx.net OK.