服务热线:15953195999
产品中心
您所在的位置:首页-新闻中心-常见问题挑选二手叉车注意“看”和“听”

挑选二手叉车注意“看”和“听”

来源:https://www.jnhgjx.net/ 日期:2022-10-18 发布人:

购买二手叉车,为的是节约投资成本,尽快产生好的经济效益,但是,如果您没有挑选好叉车,那么,您就可能“药罐子”,耽误生产不说,天天维修,是不是很闹心啊?济南二手叉车厂家认为您挑选二手叉车注意“看”和“听”!
The purpose of purchasing a second-hand forklift is to save investment costs and generate good economic benefits as soon as possible. However, if you do not select a forklift well, you may have bought a "medicine jar", which delays production and is troublesome to maintain every day? Jinan second-hand forklift manufacturers think that you should pay attention to "look" and "listen" when selecting second-hand forklift!
看:
Look:
怎么看?看那里?要站在正前方,看门架上下的间隙是否一致,如上下不一,证明此叉车曾经因超负荷长时间工作过,或有过事故.蹲下,看正后方下面的转向系统是否和介绍的一致,转向分机械和液压二种,液压也分全液压和机械液压混合的,全液压,也就是俗称的横直缸,机械的叫三联板,也许各地方叫法不同但是,具体的意思大家能明白.看所有的连接部位的间隙是否很大,如果大,证明此车使用率较高,买后,很可能会增加维修成本。
What do you think? Look at that? Stand in the front and check whether the clearance between the upper and lower parts of the portal frame is consistent. The difference between the above and the lower parts proves that the forklift has worked for a long time due to overload or has had an accident. Squat down and check whether the steering system below the front is consistent with the introduction. There are two types of steering: mechanical and hydraulic. The hydraulic pressure is also a mixture of full hydraulic and mechanical hydraulic pressure. Full hydraulic, also known as the horizontal cylinder, is called the triple plate, which may be different in different places. However, You can understand the specific meaning. Check whether the clearance of all connecting parts is large. If it is large, it proves that the car has a high utilization rate. After buying, it is likely to increase the maintenance cost.
济南二手叉车
听:
Listen:
将车发动起来,听发动机的声音是否有明显的答答声,发动机运转是否平稳,加几次长油门后,将油门放掉,看发动机的反应是否灵敏如有缺陷,您应该知道怎么做了,试:空载试车,负荷满载,看整车的性能,如果能达到新车85%以上的,应该算不错了,千万别轻信那些超载试车,大油门试车一般的问题不容易发现,空载,负荷都要小油门和中油,满载停车,熄火,看门架上的货物是否下沉,时间要5分种左右。
Start the car, listen to the sound of the engine for obvious answers, and check whether the engine runs smoothly. After several times of adding the long accelerator, release the accelerator to check whether the engine responds sensitively. If there is any defect, you should know how to do it. Try: no-load test run, full load test, and see the performance of the whole car. If it can reach more than 85% of the new car, it should be good. Don't trust those overloaded test runs, It is not easy to find the general problems in the high throttle test run. The low throttle and medium oil are required for no-load and load tests. It takes about 5 minutes to stop with full load, turn off the engine, and watch whether the goods on the gantry sink.
此外要注意,车作为一个综合性使用产品,对于性、可操纵性、舒适性、技术性、性都是有较高要求的。如果车辆本身质量低、技术差,那么使用三五年之后车况就很差了,所以一些小厂家制造的“便宜货”往往保值程度很低,车辆折旧情况严重。
In addition, as a comprehensive product, the car has high requirements for safety, maneuverability, comfort, technology, environmental protection and energy conservation. If the quality of the vehicle is low and the technology is poor, the condition of the vehicle will be very poor after three or five years of use. Therefore, the "cheap goods" manufactured by some small manufacturers tend to have low value preservation and serious vehicle depreciation.
挑选二手叉车注意“看”和“听”的相关事项就讲解到这里了,您对此有什么想咨询的问题或者需求随时来我们http://www.jnhgjx.net这里了解!
This is the end of the "look" and "listen" related matters when selecting used forklifts. If you have any questions or needs, please come to us at any time http://www.jnhgjx.net Here to understand!

济南韩工机械设备有限公司
地址:山东省济南市章丘区龙山街道济青路龙山段南侧1幢   电话:15953195999
网站:https://www.jnhgjx.net/   备案号:鲁ICP备14018186号-1  

鲁公网安备 37011202000702号

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】