低成本、率、以工作质量保证产品质量

What are the regulations for forklift operation

答：禁止叉车作业时用货叉顶货，拉货，禁止叉车超载。叉车禁止载人行驶，电并叉车禁止同时接通两个动作电路，库内和车内码放每垛高度不得超四盘，叉车在叉放易碎品、贵重品或装载不稳的货物时要用绳加固，必要时有专人扶护才能行驶

A: it is forbidden to top and pull goods with forks during forklift operation. It is forbidden to overload forklifts. The forklift is forbidden to drive with people, and the electric forklift is forbidden to connect two action circuits at the same time. The height of each stack in the warehouse and in the vehicle shall not exceed four plates. The forklift shall be reinforced with rope when forking fragile goods, valuables or unstable goods, and can only drive with the help of special personnel if necessary

叉车走行时在什么情况下要减速行驶

When the forklift is running, under what circumstances should it slow down

答：在转弯，后退、狭窄通道，路面不平，交通路口和接近货物时要减速行驶

A: slow down when turning, retreating, narrow passages, uneven roads, traffic intersections and approaching goods

叉车日常保养的内容是什么

What is the daily maintenance of forklift

答：（1）擦拭机械各部灰尘。（2）检查发动机的机油量（内燃叉车）。（3）检查蓄电池电解液比重及高度，电解液高度应高出隔板为10~15毫米，拧紧塞子，检查柱及导线接头是否紧密牢固。（4）离合器、制动器踏板的自由行程动作可靠性，检查油路有无漏油现象。（5）各种电气线路接头是否牢固，各种仪表、灵敏。

Answer: (1) wipe the dust of all parts of the machine. (2) Check the engine oil quantity (internal combustion forklift). (3) Check the specific gravity and height of the battery electrolyte. The height of the electrolyte should be 10 ~ 15mm higher than the diaphragm. Tighten the plug and check whether the column and wire joints are tight and firm. (4) The free stroke action reliability of clutch and brake pedal, and check the oil circuit for oil leakage. (5) Whether the connectors of various electrical lines are firm and whether various instruments are sensitive.

职工共同遵守的劳动守则的内容是什么

What is the content of the labor code that employees jointly abide by

答：四做到：做到班前充分休息、做到工作精力集中，做到正确着用护品、做到横过线路一站二看三通过

Answer: Four: have a full rest before work, concentrate on work, use protective articles correctly, and cross the line at one stop, two views and three passes

七不准：不准擅离岗位、不准飞乘飞降、不准随车捎脚，不准钻越车辆、不准抢越线路、不准走枕木头和线路中间

VII. No: no leaving the post without permission, no flying on and off, no walking with the vehicle, no crossing the vehicle, no jumping over the line, no walking between the pillow wood and the line

叉车在棚车内作业的要求是什么

What are the requirements for forklift operation in the box car

答：在徐州叉车维修棚车内作业外侧无站台时，车门开度不得超过叉车宽，否则要加以防护。站台与车内连接处要设有渡板。其坡度不得大于20％，车内地板腐朽残破时，要铺垫钢板作业

Answer: when there is no platform outside the box car for forklift maintenance in Xuzhou, the door opening shall not exceed the width of the forklift, otherwise it shall be protected. Transition plates shall be set at the connection between the platform and the vehicle. The gradient shall not be greater than 20%. When the floor in the vehicle is decayed and broken, steel plate shall be paved for operation

叉车在进行危险品作业时应遵守的规定是什么

What are the regulations that forklifts should follow when working with dangerous goods

答：普通叉车不得进行危险货物中的易燃易爆物品作业；进行危险品中的毒害品，放射性物品作业的装卸机械降低25％负荷使用，作业中要轻拿轻放，禁止摔碰、撞击，拖拉等剧烈震动

Answer: ordinary forklifts are not allowed to operate inflammables and explosives in dangerous goods; The loading and unloading machinery for toxic and radioactive substances in dangerous goods shall be reduced by 25%. It shall be handled with care during operation. Violent vibration such as falling, collision and dragging are prohibited

叉车会让的要求是什么

What are the requirements for forklifts

答：叉车行驶靠右边，货叉应升起离地面200~300毫米

Answer: the forklift is driven on the right, and the fork should be raised 200 ~ 300mm above the ground

叉车会让时，应空车让重车，下坡车让上坡车，支线让干线，大转弯让小转弯，出入车门、库门时，让出库门、出车门的车先行

When the forklift will give way, the empty vehicle shall give way to the heavy vehicle, the downhill vehicle shall give way to the uphill vehicle, the branch line shall give way to the trunk line, and the big turn shall give way to the small turn. When entering and leaving the door and garage door, the vehicles leaving and leaving the door shall take the lead

内燃叉车交接班应检查的项目有哪些

What items should be checked during shift handover of internal combustion forklift

答：应检查燃料、机油，冷却水是否充足，风扇皮带松紧程度，风窗通畅或冬季防寒情况，轮胎充气、坚固情况。启动试车检查转向，制动（包括手制动）各工作机构运行情况

A: check whether the fuel, engine oil and cooling water are sufficient, the tightness of fan belt, the unobstructed wind window or cold protection in winter, and the inflation and firmness of tires. Start the test run and check the operation of all working mechanisms of steering and braking (including hand braking)

叉车时施作业标准中对“起车”的技术要求是什么

What are the technical requirements for "lifting" in the forklift operation standard

答：起车应达到以下技术要求：（1）门架后倾。（2）提叉地面0.2~0.3m.（3）了望、鸣笛。（4）一档起步，逐换档。（5）平稳加速

Answer: the following technical requirements shall be met when starting: (1) the gantry tilts back. (2) Lift the fork to 0.2 ~ 0.3m above the ground. (3) lookout and whistle. (4) Start in first gear and shift gears one by one. (5) Steady acceleration

本文的精彩内容由济南叉车租赁提供，本网站还有很多的精彩内容，更多的内容您可以点击进入：http://www.jnhgjx.net我们有专门的客服为您解答问题

The wonderful content of this article is provided by Jinan forklift leasing. There are many wonderful content on this website. You can click to enter more content: http://www.jnhgjx.net We have special customer service to answer your questions