全国服务热线:15953195999
产品中心
您所在的位置:首页-新闻中心-新闻动态-轮胎更换好了能与延长叉车的使用寿命

轮胎更换好了能与延长叉车的使用寿命

来源:http://www.jnhgjx.net/ 日期:2022-03-25 发布人:hangong

轮胎换位到底有无必要?汽车按驱动方式分为前驱、后驱和四驱,驱动轮和非驱动轮受力不一样,轮胎在前和在后受力也不一样,汽车向左侧和向右侧转向同样会造成轮胎不能同步磨损,这就导致四个轮胎必不能均匀磨损。汽车行驶较长里程公里数后,轮胎不均匀的磨损现象会越发严重,轮胎的不均匀磨损势必会造成轮胎的使用寿命不一致,如果让前后轮胎磨损均匀、使用寿命一致,让全部轮胎甚至延长2年的使用寿命并不夸张。所以,轮胎前后调换目的就是为了避免轮胎长时间受单一方向的磨损。定期交换轮胎位置,就是为了使轮胎磨损均衡,有利于汽车操控稳定及行驶,可以延长轮胎的使用寿命。

Is tire transposition necessary? The automobile is divided into front drive, rear drive and four-wheel drive according to the driving mode. The force on the driving wheel and non driving wheel is different, and the force on the tire is also different in the front and rear. Turning to the left and right will also cause the tire to be unable to wear synchronously, which will lead to the uneven wear of the four tires. After a long mileage, the uneven wear of tires will become more and more serious. The uneven wear of tires is bound to cause inconsistent service life of tires. If the wear of front and rear tires is uniform and the service life is consistent, it is not exaggeration to extend the service life of all tires by even 2 years. Therefore, the purpose of tire replacement is to avoid tire wear in a single direction for a long time. The regular exchange of tire positions is to make the tire wear balanced, which is conducive to the stable operation and driving of the vehicle, and can prolong the service life of the tire.
各种轮胎调位方法并不是千篇一律,因为并不是所有的汽车驱动轮位置是相同的,要根据汽车实际情况,遵守正确的互换方法,因为汽车分为前轮驱动、后轮驱动还有四驱,互换方法是不尽相同的。正确的方法是前驱车为驱动轮垂直换,左前到左后,右前到右后。非驱动轮对角换,右后到左前,左后到右前。也就说是非四驱车型的轮胎换位的原则是:驱动轮垂直换,非驱动轮对角换。像后驱车就需要左前到右后,右前到左后,左后到左前,右后到右前。如果是四驱车型的话,则是直接垂直前后换即可,例如左前到左后,右前到右后。
Various tire alignment methods are not the same, because not all vehicle driving wheel positions are the same. According to the actual situation of the vehicle, observe the correct exchange method, because the vehicle is divided into front wheel drive, rear wheel drive and four-wheel drive, and the exchange method is different. The correct method is to drive forward and change the driving wheel vertically, from front left to rear left, and from front right to rear right. The non driving wheels are shifted diagonally, from rear right to front left, and from rear left to front right. In other words, the principle of tire transposition for non 4WD models is: the driving wheel is changed vertically and the non driving wheel is changed diagonally. For example, rear driving requires left front to right rear, right front to left rear, left rear to left front, right rear to right front. If it is a 4WD model, it can be changed directly vertically back and forth, such as left front to left rear, right front to right rear.
轮胎换位可以防止轮胎偏磨,可以防止叉车过早的跑偏及抖动,可以延长轮胎使用寿命。为保证前后轮胎磨损均匀,四个轮胎使用寿命同步,对于一般汽车可以每行驶1万公里将轮胎换位一次。
Tire transposition can prevent tire eccentric wear, premature deviation and shaking of forklift, and prolong tire service life. In order to ensure uniform wear of the front and rear tires, the service life of the four tires is synchronized. For ordinary cars, the tires can be transposed every 10000 kilometers.
再来说一说关于轮胎使用方面的小提示:
Let's talk about the tips on tire use:
1、考虑到大多数汽车为前轮驱动,驱动前轮要比后轮磨损快,应着重注意前轮轮胎的使用情况
1. Considering that most cars are front wheel driven, the wear of driving front wheels is faster than that of rear wheels, we should pay attention to the use of front wheel tires
2、勤检查轮胎,对于轮胎偏磨的情况能早发现、早处理,避免出现“吃胎”现象带来的隐患。
2. Check the tires frequently, find and deal with the tire eccentric wear early, so as to avoid the hidden danger caused by the phenomenon of "eating tires".
3、前后轮胎胎压不同,前后轮胎换位后一定要记得要重新设定胎压。
3. The tire pressure of the front and rear tires is different. Remember to reset the tire pressure after the front and rear tires are transposed.
4、如果发现轮胎存在过早磨损、不正常磨损的现象,除需要做四轮定位外,还应提前进行轮胎的换位。
4. If the tire is found to be worn prematurely or abnormally, in addition to four-wheel alignment, the tire shall be transposed in advance.
5、有方向性花纹的轮胎(单导向轮胎)调位一定要注意,千万不可安装反了,安装时要按照轮胎上的箭头方向安装。因此单导向胎只能前后轮直向对调而不能交叉换位。
5. Attention must be paid to the alignment of tires with directional patterns (single guide tires). Do not install them reversely. Install them in the direction of the arrow on the tire. Therefore, the single guide tire can only adjust the front and rear wheels in a straight direction instead of cross transposition.
 

济南韩工机械设备有限公司
地址:山东省济南市章丘区龙山街道济青路龙山段南侧1幢   电话:15953195999
网站:http://www.jnhgjx.net/   备案号:鲁ICP备14018186号-1  技术支持:网站建设·推广运营

鲁公网安备 37011202000702号

 

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】