服务热线:15953195999
产品中心
您所在的位置:首页-新闻中心-新闻动态叉车遇到问题怎么解决​?需要注意什么?

叉车遇到问题怎么解决​?需要注意什么?

来源:https://www.jnhgjx.net/ 日期:2022-01-17 发布人:

液压升降机上升无法达到规定的高度问题应该按照以下方式进行解决:

The problem that the hydraulic lift cannot reach the specified height shall be solved in the following ways:
一:液压升降机无法达到高度,先要检查的液压箱是否出现漏气现象,因为出现漏气现象会导致气压不稳定,导致动力下降,无法上升到高度。如手动叉车
1: If the hydraulic elevator cannot reach the height, first check whether there is air leakage in the hydraulic tank, because the air leakage will lead to unstable air pressure, reduce the power and fail to rise to the height. Such as manual forklift
二:液压升降机的液压油是否该更换了,如果多次使用了液压油,液压油的耐磨性与耐压性严重下降,会导致压力严重下降,液压升降机升降高度会无法达到标准化。如电动搬运车
2: Whether the hydraulic oil of the hydraulic elevator should be replaced. If the hydraulic oil is used for many times, the wear resistance and pressure resistance of the hydraulic oil will be seriously reduced, which will lead to a serious drop in pressure, and the lifting height of the hydraulic elevator will not be standardized. Such as electric truck
三:液压升降机的动力系统是否出现问题。不管第四:液压升降机的支撑臂关键部位是否出现异物阻碍现象,清理关键部位的整洁性。如全电动叉车是柴油机还是电力启动系统是否达到升降所需要求标准,如果条件达不到会导致设备受损。
3: Whether there is a problem with the power system of the hydraulic elevator. No matter the fourth: whether the key parts of the support arm of the hydraulic elevator are obstructed by foreign matters, clean the cleanliness of the key parts. For example, whether the all electric forklift is diesel engine or electric starting system meets the required standards for lifting, and if the conditions are not met, the equipment will be damaged.
1、天气炎热,内燃叉车、电动叉车易出现散热器“开锅”、供油系统气阻、蓄电池叉车“亏水”、液压制动因皮碗影响膨胀变形而导致失灵,以及轮胎内的气压随着外界气温升高发生爆炸等影响生产作业的不利现象。
1. In hot weather, internal combustion forklifts and electric forklifts are prone to adverse phenomena affecting production operations, such as "boiling" of radiators, air resistance of oil supply system, "water loss" of battery forklifts, failure of hydraulic braking due to expansion and deformation affected by leather cups, and explosion of air pressure in tires with the increase of external temperature.
2、调整内燃叉车、电动叉车发动机调节器,适当降低充电电流和电压。
2. Adjust the engine regulator of internal combustion forklift and electric forklift, and appropriately reduce the charging current and voltage.
3、内燃叉车作业中,随时注意冷却液温度表的指示读数,防止内燃叉车、电动叉车发动机过热。如果冷却液温度过高,要采取降温措施,保持冷却液的液位,添加时要注意防止冷却液。
3. During the operation of internal combustion forklift, pay attention to the indication reading of coolant thermometer at any time to prevent the engine of internal combustion forklift and electric forklift from overheating. If the coolant temperature is too high, take cooling measures to maintain the coolant level, and pay attention to prevent coolant from being added.
4、进入暑期,应提前做好内燃叉车、电动叉车的换季保养,放出发动机、驱动桥、变速器、转向机等处的冬季润滑油脂,清洗后按规定加注夏季用的润滑油脂。
4. In summer, the seasonal maintenance of internal combustion forklift and electric forklift shall be carried out in advance, the winter lubricating grease at the engine, drive axle, transmission and steering gear shall be discharged, and the lubricating grease used in summer shall be filled according to the regulations after cleaning.
本文由济南叉车租赁为您提供,我们的网站是:http://www.jnhgjx.net我们将以全心全意的热情为您提供服务,欢迎您的访问!
This article is provided by Jinan forklift leasing. Our website is: http://www.jnhgjx.net We will serve you with wholehearted enthusiasm. Welcome to visit!

济南韩工机械设备有限公司
地址:山东省济南市章丘区龙山街道济青路龙山段南侧1幢   电话:15953195999
网站:https://www.jnhgjx.net/   备案号:鲁ICP备14018186号-1  

鲁公网安备 37011202000702号

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】