二手叉车行驶过程中需要注意什么?
来源:https://www.jnhgjx.net/ 日期:2021-11-30 发布人:
行驶时,货叉底端距地面高度应保持300-400mm门架须后倾。
When driving, the height between the bottom end of the fork and the ground shall be 300-400mm, and the gantry must tilt back.
行驶时不得将货叉升得太高。进出作业现场或行驶途中,要注意上空有无障碍物刮碰。载物行驶时,如货叉又升得太高,还会增加叉车总体高度,影响叉车的稳定性。
Do not raise the fork too high while driving. When entering or leaving the operation site or driving, pay attention to whether there are obstacles in the sky. When the load is running, if the fork rises too high, the overall height of the forklift will be increased and the stability of the forklift will be affected.
卸货后应先降落货叉正常的行驶位置后再行驶。
After unloading, lower the fork to the normal driving position before driving.
转弯时,如附近有行人或车辆,应发出信号并禁止高速急转弯。高速急转弯会导致车辆
When turning, if there are pedestrians or vehicles nearby, send a signal and prohibit sharp turning at high speed. Sharp turns at high speeds can cause the vehicle to
失去横向稳定而倾翻。
Lose lateral stability and tip over.
内燃叉车在下坡时严禁熄火滑行。
The internal combustion forklift is strictly prohibited from stalling and sliding down the slope.
非特殊情况,禁止载物行驶中急刹车。
It is forbidden to brake suddenly when the load is running except under special circumstances.
载物行驶在超过7度和用高于一挡的速度上下坡时,非特殊情况不得使用制动器。
When the load is driving over 7 degrees and going uphill and downhill at a speed higher than the first gear, the brake shall not be used except under special circumstances.
叉车在运行时要遵守厂内交通规则,与前面的丰辆保持一定的距离。
The forklift shall comply with the traffic rules in the plant and keep a certain distance from the Feng vehicle in front.
叉车运行时,载荷处在不妨碍行驶的位置,门架要适当后倾,除堆垛或装车时,
When the forklift is running, the load is in a position that does not hinder driving, and the gantry shall be tilted back properly, except when stacking or loading,
不得升高载荷。在搬运庞大物件时,物体挡住驾驶员的视线,此时应倒开叉车。
Do not raise the load. When handling large objects, the objects block the driver's line of sight. At this time, the forklift should be reversed.
叉车由后轮控制转向,所以时刻注意车后的摆幅,避免初学者驾驶时经常出现的转
The forklift is controlled by the rear wheel, so always pay attention to the swing behind the forklift to avoid the frequent turning when driving for beginners
弯过急现象。
Excessive bending.
禁止在坡道上转弯,也不应横跨坡道行驶。
It is forbidden to turn on the ramp or drive across the ramp.
叉车载货下坡时,应倒退行驶,以防货物颠落。
When the forklift is carrying goods downhill, it shall travel backward to prevent the goods from falling.
The wonderful content of this article is provided by Jinan forklift leasing knowledge. There are many wonderful content on this website. You can click to enter more content: http://www.jnhgjx.net We have special customer service to answer your questions