服务热线:15953195999
产品中心
您所在的位置:首页-新闻中心-新闻动态化气叉车在使有的过程中如何做到合理?

化气叉车在使有的过程中如何做到合理?

来源:https://www.jnhgjx.net/ 日期:2021-10-15 发布人:

1.熟悉液化气叉车的相关手册,对液化气转换系统有一个的认识与了解,在叉车的使用过程中,不可将叉车停在接近热源或火源的地方,如明火、燃烧的烟蒂、火星、电焊、能产生高温的机器及电气设备旁;不可擅自动手调整或修改液化气转换装置;应按期实施定期保养及检查;保持警觉,发现任何泄漏或异常现象应立即处理。

1. Firstly, be familiar with the relevant manuals of liquefied gas forklift and have a comprehensive understanding of liquefied gas conversion system. During the use of forklift, do not stop the forklift near the heat source or fire source, such as open fire, burning cigarette butts, sparks, electric welding, machines and electrical equipment that can produce high temperature; Do not adjust or modify the liquefied gas conversion device without authorization; Regular maintenance and inspection shall be carried out on schedule; Keep alert and deal with any leakage or abnormality immediately.
2.做到合理的启动:双燃料如使用液化气气体,工作前应确认钢瓶上手动阀门是否已完全打开,叉车在常期闲置不用时,应将其手动阀门关闭;启动时不必踩油门,双燃料系统必须将切换开关旋置液化气位置,启动后,尤其天寒地带,好是暖车两三分种,让内燃机之冷却水系统升温后再行驶,以确保温水可流入汽化器,以加速汽化。
2. Reasonable startup: if liquefied gas is used for dual fuel, confirm whether the manual valve on the steel cylinder has been fully opened before operation. When the forklift is idle for a long time, close its manual valve; When starting, it is not necessary to step on the accelerator. For the dual fuel system, the change-over switch must be turned to the liquefied gas position. After starting, especially in cold areas, it is best to warm up the vehicle for two or three minutes, and let the cooling water system of the internal combustion engine warm up before driving, so as to ensure that the heat preservation water can flow into the carburetor to accelerate vaporization.
济南叉车租赁
3.注意燃油切换方法(单燃料叉车不需考虑):对双燃料叉车而言,切换时应在叉车停稳时,且不可在行驶中切换;在汽油转换液化气时,让内燃机继续以怠速运转,此时可将切换开关旋中位,让化油器内积存汽油烧完为止,直熄火,再将燃油切换开关旋液化气位置,重新启动;由液化气转换到汽油时,可直接将切换开关旋汽油位置不必停在中位,此时注意拔出拉索,双燃料系统在主要以烧液化气为主时,需让汽油箱内保持少1/4的油量以备不时之需。且偶尔地需烧汽油,以确保汽油系统不因闲置过久而出现故障,防止输油管脆化,建议每个月烧10公斤汽油为好。
3. Pay attention to the fuel switching method (single fuel forklift does not need to be considered): for dual fuel forklift, the switching shall be when the forklift stops stably and cannot be switched during driving; When the gasoline is converted to liquefied gas, let the internal combustion engine continue to run at idle speed. At this time, turn the change-over switch to the middle position, let the gasoline accumulated in the carburetor burn out until the engine stops, and then turn the fuel change-over switch to the liquefied gas position and restart; When switching from liquefied gas to gasoline, you can directly turn the change-over switch to the gasoline position without stopping at the middle position. At this time, pay attention to pull out the cable. When the dual fuel system is mainly burning liquefied gas, it is necessary to keep at least 1 / 4 of the oil in the gasoline tank for emergency needs. It is also necessary to burn gasoline occasionally to ensure that the gasoline system will not fail due to idle for too long and prevent the embrittlement of the oil pipeline. It is recommended to burn 10kg of gasoline every month.
4.做到正确地加气:加气有两种方式,一为换瓶;二为在叉车上直接充气。加气或换瓶时必须在室外,保证通风良好,应符合当地的消防标准的规定要求。叉车必须停稳、熄火,驾驶员离开驾驶座。四周严禁烟火、热源、火源。小心地处理钢瓶,不得碰撞、摔掷、或在地面上滚动。加气人员在加气的过程中必须全程监视,不得离开现场。充气时,将加气枪套在瓶上的填充阀上,并旋紧,同时将瓶上的80%的液位孔旋开,开始加气。当80%液位孔有白雾冒出时,应立即停止加气,将80%液位孔旋紧关闭,并检查液面计指示量是否正确。
4. Add gas correctly: there are two ways to add gas: one is to change the bottle; Second, directly inflate the forklift. When filling or changing bottles, they must be outdoors to ensure good ventilation and safety, which shall meet the requirements of local fire protection standards. The forklift must stop steadily and turn off the engine, and the driver must leave the driver's seat. Fireworks, heat sources and fire sources are strictly prohibited around. Handle cylinders carefully and do not collide, throw, or roll on the ground. The gas filling personnel must monitor the whole process of gas filling and shall not leave the site. When inflating, put the dispenser gun on the filling valve on the bottle and tighten it. At the same time, open 80% of the liquid level hole on the bottle to start inflating. When the 80% liquid level hole emits white mist, stop gas filling immediately, screw the 80% liquid level hole tightly and close it, and check whether the indication of the liquid level gauge is correct.

济南韩工机械设备有限公司
地址:山东省济南市章丘区龙山街道济青路龙山段南侧1幢   电话:15953195999
网站:https://www.jnhgjx.net/   备案号:鲁ICP备14018186号-1  

鲁公网安备 37011202000702号

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】