低成本、率、以工作质量保证产品质量

Forklift brake pad

叉车刹车片呈现磨损，在正常的叉车驾驭行车中，靠感觉是感觉不出来的。有些能够直接查看，但有些车型需求拆开出来才干看到。正常的刹车片有9毫米厚，当磨到2-3毫米时就必须换了；等全磨破显露刹车片附着的金属片，这样就会呈现金属与金属冲突的异响。梯诺机械表明替换刹车片时一般修理工都是让一切有相关的叉车配件都一同换掉，正常状况下都是能够单换的，如：仅仅单刹车分泵漏油，换了刹车分泵后刹车片能够清洗洁净刹车片和刹车轮毂，假如是刹车片磨损的话刹车轮毂没磨损，只换刹车片就能够了，别的配件就清洗洁净，轴承方位再从头增加新的黄油即可，悉数安装好后再调 下刹车片和刹车轮毂之间的空隙就能够正常运用了。

The forklift brake pad is worn out, and it can not feel out of the normal forklift driving. Some can directly view, but some models need to be opened up to see. Normal brake pads are 9 mm thick and must be replaced when they are ground to 2-3 mm. When the metal pads attached to the brake pads are completely worn out, the abnormal sound of metal-metal conflict will appear. Tino Machinery shows that when replacing brake pads, the general repairman replaces all relevant forklift parts together. Normally, they can be replaced separately. For example, only the single brake pump leaks oil, the brake pads after replacing the brake pump can clean the brake pads and the brake wheel hub, if the brake pads wear out, the brake wheels can be cleaned. If the hub is not worn out, just change the brake pads, the other parts will be cleaned and cleaned, and the bearing orientation can be added with new butter from scratch. After all installation, the gap between the brake pads and the hub of the brake wheel can be adjusted to normal use.

二、叉车火花塞

Two. Forklift spark plug

叉车火花塞是在修理时有许多的修理商都会劝叉车用户提早替换的小配件，但实际上假如驾驭员在用车时没感觉到有点火不良、加快不力、没有放炮等缺点现象的话就能够不替换。但是定时要拆出来查看是有必要的，但假如火花塞确实坏了就一定要及时替换，有些车型坏了的火花塞还会呈现掉落掉在发动机的汽缸里面，这样就会引发更大的叉车缺点。

Forklift spark plug is a small part that many repairmen will advise forklift users to replace earlier, but in fact, if the driver does not feel a little bad fire, slow speed, no artillery and other shortcomings when using the vehicle, he can not replace it. But it is necessary to take it out regularly, but if the spark plug does break down, it must be replaced in time. Some of the broken spark plugs will fall into the engine cylinder, which will lead to greater shortcomings of forklift trucks.

三、叉车刹车油

Three. Forklift brake oil

正常状况下修理工一般要求1年左右即进行替换，但实际没太大缺点，假如叉车制动体系配件未呈现异常就不必替换。但需常常查看有没有短少或许变质或许也能够通过目测，假如刹车油低于低液面就真的需求换或许直接增加了。叉车刹车油假如严峻短少会影响到刹车的制动功能，在替换叉车刹车油必需要换正品的，不是正品的用久了后会形成整套刹车体系会失灵。梯诺机械表明关于刹车油是否正品的检测方法能够用以下这个方法：伸个手指进到刹车油瓶内，泡到刹车油后然后伸出来在正常空气中一分钟左右手指有发热的感觉，根本能够判别为这款叉车刹车油为正品。

Under normal conditions, repairmen usually require replacement within one year or so, but there are not too many shortcomings in practice. If the brake system accessories of forklift truck do not show abnormalities, it is not necessary to replace them. However, it is often necessary to check whether there is any shortage or deterioration, or to be able to pass visual inspection. If the brake oil is below the minimum level, the real demand may increase directly. Forklift brake oil, if severe, will affect the braking function of the brake. In order to replace the brake oil of the forklift, it is necessary to replace the genuine brake oil. If not the genuine brake oil is used for a long time, the whole brake system will fail. Tino Machinery shows that the detection method of whether the brake oil is genuine can use the following method: stretch one finger into the brake oil bottle, soak into the brake oil, and then stretch out in normal air for about a minute, the finger has a fever feeling, can basically distinguish the forklift brake oil as genuine.

四、叉车机油

Four. Forklift oil

一些进口的机油正常状况下是在1500小时进行替换，而国产的机油一般是在750个小时左右就必需要替换。但实际上只要油色明澈、油面不低于标明的低液面，没有特殊状况下机油的替换也不必那么频频。运用频频的叉车（操作超越十个小时以上）能够一个月左右替换，运用需求一般的叉车（操作在正常的八小时内）能够三个月左右保养一次，而运用较少的叉车（操作不超越三小时的）主张要半年保养一次，要不会形成发动机容易磨损和光滑欠好的状况，机油必须挑选正品的来运用。

Some imported oil is normally replaced in 1500 hours, while domestic oil is usually replaced in 750 hours or so. But in fact, as long as the oil color is clear and the oil level is not lower than the lowest level indicated, the replacement of oil does not have to be so frequent without special conditions. Frequently used forklift trucks (operating more than 10 hours a day) can be replaced within one month or so, forklift trucks with general demand (operating in normal eight hours a day) can be maintained about three months, while forklift trucks with less use (operating less than three hours a day) advocate that it should be maintained half a year, or not. It will cause the engine to wear and smooth easily. The oil must be selected for proper use.

五、叉车液压油

Five, forklift truck hydraulic oil

叉车的液压油是不需求常常换，在正常状况下是3-5年左右再换一次，假如在运用中有漏油状况增加新的液压油即可，液压油要看在运用中的清洁度来决议是否替换，在挑选液压油好是正品的，又是比较知名大的即可。

The hydraulic oil of forklift truck does not need to be replaced frequently. In normal condition, it will be replaced again for about 3-5 years. If there is oil leakage in operation, new hydraulic oil can be added. The hydraulic oil depends on the cleanliness in operation to decide whether to replace it. In selecting hydraulic oil, it is better to be genuine, and it is also a relatively well-known brand.