电动叉车防漏措施有哪些?
来源:https://www.jnhgjx.net/ 日期:2022-04-18 发布人:
妥善处理各种衬垫。例如发动机油盘或阀盖,因其接触面积大,不易压实,易产生漏油。曲轴油封上有漏油,润滑油就会渗入离合器中,既费油又会使离合器片沾上污垢,从而烧损。
Properly handle all kinds of gaskets. It is not easy to contact the oil pan, for example, the oil pan is not easy to be compacted due to its large area. If there is oil leakage on the crankshaft oil seal, the lubricating oil will penetrate into the clutch, which will not only consume oil, but also make the clutch plate stained with dirt and burn.
按照维修要求将每个螺母拧紧。过紧的松压衬垫会渗油;过紧会使螺孔周围金属凸起,或者扭滑造成漏油。如果机器油盘(壳体)放油螺塞不紧固或松脱,很容易造成大量机油流失,进而发生“烧瓦抱轴”事故。
Tighten each nut according to the maintenance requirements. Too tight loose packing will leak oil; Too tight will make the metal around the screw hole bulge, or twist and slip, resulting in oil leakage. If the oil drain plug of the machine oil pan (shell) is not fastened or loose, it is easy to cause a large amount of oil loss, and then the accident of "burning tile and holding shaft" will occur.
迅速更换故障油封。不恰当的油封安装、轴颈与油封刃口不同心,容易因偏移而甩油;有的经过长时间使用后,会由于橡胶老化而失去弹性,密封唇口损坏,或自紧簧失效,会丧失封油作用,应按标准进行维修或更换合格的配件。
Replace the faulty oil seal quickly. Improper installation of the oil seal and the misalignment between the journal and the oil seal edge make it easy to throw oil due to offset; After a long time of use, some rubber will lose elasticity due to aging, the sealing lip will be damaged, or the self tightening spring will lose its oil sealing effect. They should be repaired or replaced with qualified accessories according to the standard.
对磨损严重的零件及时更换。举例来说,气缸套、活塞、活塞环磨损到一定程度,燃烧室中的高压气体就会窜进曲轴箱。
Replace the severely worn parts in time. For example, when the cylinder liner, piston and piston ring are worn to a certain extent, the high-pressure gas in the combustion chamber will rush into the crankcase.
1.外观:蓄电池表面脏污会造成漏电,搬运车时,应使蓄电池表面随时清洁、干燥。
1. Appearance: the dirty surface of the battery will cause electric leakage. When transporting the vehicle, the battery surface should be clean and dry at any time.
2.接线柱、导线、盖子:应经常检查电瓶接头,因氧化而产生腐蚀,并检查电瓶盖有无变形及发热现象。
2. Terminal, wire and cover: the battery connector shall be checked frequently to prevent corrosion due to oxidation, and the battery cover shall be checked for deformation and heating.
3.液面:在液面标定以下,会缩短蓄电池的使用寿命,而电解液过少会造成蓄电池发热和损坏,因此,要经常检查电解液是否充足。
3. Liquid level: below the liquid level calibration, the service life of the battery will be shortened, and too little electrolyte will cause heating and damage of the battery. Therefore, it is necessary to often check whether the electrolyte is sufficient.
The above is a detailed introduction about Jinan forklift leasing. I hope it will help you If you have any questions, please contact us We will provide you with professional service http://www.jnhgjx.net